====== Using FollowMe on your own MacOS machine ====== German information is available at [[https://www.zedat.fu-berlin.de/tip4u_159.pdf|ZEDAT Tip4U (German only)]]. ===== Installing the printer ===== To install the FollowME printer on your device, download the [[https://www.zedat.fu-berlin.de/pub/ZEDAT/Print/DruckScanUnbetreut/FollowMe%20IPP.pkg|installation package]]. Click on the package to start the installation. {{ :print:followme_macos_0.png |}} Click on **continue**. {{ :print:followme_macos_1.png |}} Choose the installation disk, this should be the disk with your MacOS installation. Click on **continue**. {{ :print:followme_macos_2.png |}} Click on **install**. {{ :print:followme_macos_3.png |}} Type in your password and click on **Install Software** to install the printer. {{ :print:followme_macos_4.png |}} Click on **OK**. {{ :print:followme_macos_5.png |}} **Click on finish** Now your MacOS device is set up to print using the followme printers. ===== Using the printer ===== The default print setting will be duplex (double-sided) printing. You can change the defaults in the CUPS UI. Please note, that printing to FollowMe will only work if either: * connected from a University Network * connected from Eduroam * connected with ZEDAT or ZEDV VPN To use the FollowMe printer, select the printer in the printing dialog. {{ :print:followme_macos_6.png |}} Upon sending the print job MacOS will ask you to authenticate the print Job. Enter your **ZEDAT Credentials**, **not** your local MacOS user & password. {{ :print:followme_macos_7.png |}} After authenticating your print job will have been send to the FollowMe printer and is ready for printing.